Slope is measured from horizontal — 0° = flat frame, 90° = vertical box.
Presets: 0° flat frame · 15° planter · 30° shadow box · 90° vertical box
35.3°
Miter (table swing)
30.0°
Bevel (blade tilt)
Both readings are degrees from a square cut (0° = square), matching miter-saw scales. A table-saw miter gauge reads 90° at square instead — set it to 90 − 35.3° = 54.7°.
Every side gets the same miter and bevel on both ends. Angle errors stack across 8 cut faces, so sneak up on the settings with test cuts from scrap before touching the good stock.
Built by Sawdust Math